ENGINE
Cummins 6 CTA8.3,6-cylinder, turbocharged diesel, 234 H P (174 kw) 0 2,200 rpm.

PROPEL SYSTEM
Variable-displacement hydraulic pumps driving twospeed planetaries. Paving speed 0-330 f pm (1100.6 m/ min.); travel speed 0-12.2 mph (19.6 kph).

ELECTRICAL SYSTEM
Heavy-duty 24-volt starting system with 12-volt operating system. 90-amp alternator. All electric-overhydraulic solenoids have manual override.

AUGERS
17"(432mm)x3/4'(19.1 mm) thick Ni-hard, hydraulicilly-ralsable auger system with tilt capabilities which allow the operator to maintain a parallel position of the auger and screed bottom.

TIRES
Drive -- two 21:00 x 25' (53.3 m x 635 mm) hydroflatedhigh-flotation. Front --four 14'wide x 22' diameter (356 mm x 559 mm) solid rubber.

SCREED
10' (3.0 m) standard vibratory screed equipped with 32" (813 mm) wide, 1/2' (12.7 mm) thick T-1 plate replaceable wearing surface. Crowning capacity of 3.5% positive to 0.1 % negative.

FUME EXTRACTION SYSTEM
Two blowers -- total air flow 4,200 cu f/min. (118.9 cu m/min.). Fold-down 10" (254 mm) exhaust pipe.

SERVICE CAPACITY
Fuel 140 gal (530 L)
Cooling system 13 gal (49.2 L)

Hopper 12tons(10.9MT)
    material 110 lbs/cu ft (1,762 kg/cu m)

WEIGHTS (approximate)

    With standard screed 43000lbs(19,504 kg)
    With extendable screed 45,200lbs (20,502 kg)

OPTIONS
SCREED EXTENSIONS
Standard screed may be extended to 24'(7.3 m) with no external support and 42' (12.8 m) with external support using 6' (152 mm), 12' (305 mm), 24' (610 mm) and 36"(914 mm) extensions. A 24"(610 mm) extension is available with crowning.

TUNNEL AND AUGER EXTENSIONS
Tunnel and Ni-hard auger extensions are available to optimize material feed kross the screed when using screed extensions.

HYDRAULIC STRIKE-OFF EXTENSIONS
Left-and right-hand hydraulic strike-offs permit rapid changes in paving widths up to 4' (11.2 m) on either side of the 10' (3.0 m) standard screed while paving. Either side may be articulated from 6.6% to negative 3.3% for crown or wedge courses by use of electric Jack Screws or hydraulically.

AUTOMATIC GRADE CONTROL
An electric/hydraulic system that automatically controls the elevation of the mat being placed on one side of the machine with respect to a reference surface such as an adjacent mat orcurb. Also available in sets to control mat elevation on boW sides of the paver/ finisher simultaneously.

AUTOMATIC SLOPE CONTROL
Slope may be maintained with respect to either the right or left reference grade of the screed.

AVERAGING SKI
30' (9.1 m) and 40' (12.2 m) ft provide improved leveling of existing surfaces by providing an average reference grade for the automatic grade control.

CUTOFF SHOES
One- and two-foot (0.3 m and 0.6 m) cutoff shoes are available for reduced-width paving.

PROPANE BURNERS
HYDRAULIC GENERATOR
HOPPER INSERT FOR SHUTTLE BUGGY USE SONAR SLOPE AND GRADE CONTROLS